- Remove USE_XLIB/USE_X_PREFIX/USE_XPM in favor of USE_XORG
- Remove X11BASE support in favor of LOCALBASE or PREFIX
- Use USE_LDCONFIG instead of INSTALLS_SHLIB
- Remove unneeded USE_GCC 3.4+
Thanks to all Helpers:
Dmitry Marakasov, Chess Griffin, beech@, dinoex, rafan, gahr,
ehaupt, nox, itetcu, flz, pav
PR: 116263
Tested on: pointyhat
Approved by: portmgr (pav)
XFree86 (3 or 4) to depend to when USE_XLIB is set.
XFREE86_VERSION defaults to 3 for now, but adventurous users can
override it in /etc/make.conf. When XFREE86_VERSION=3, USE_XLIB
will add a dependency to x11/XFree86; when it is set to 4, the
dependency will be to x11/XFree86-4-libraries. When
XFREE86_VERSION=4, the PKG_IGNORE_DEPENDS and ALWAYS_BUILD_DEPENDS
hacks to avoid messing with XFree86 are turned off.
Since XFree86 version 4 includes some software that used to be
separate ports, when XFREE86_VERSION=3 the following variables are
provided:
USE_DGS LIB_DEPENDS on x11/dgs
USE_FREETYPE LIB_DEPENDS on print/freetype
USE_MESA LIB_DEPENDS on graphics/Mesa3
USE_XPM LIB_DEPENDS on graphics/xpm
When XFREE86_VERSION=4, these variables have no effect. The
LIB_DEPENDS in the tree for the above four ports have all been
converted to the USE_* counterparts. For your information, this
is the count of the number of ports:
USE_DGS 0
USE_FREETYPE 16
USE_MESA 36
USE_XPM 236
There is a new variable, XAWVER, which is set to 6 when
XFREE86_VERSION=3 and 7 when XFREE86_VERSION=4. This is also
passed to PLIST_SUB so ports that build Xaw based shared libraries
can use this variable to substitute the shlib version number.
There is also a provision of using a separate mtree file for
XFREE86_VERSION=4, but that part is not enabled yet.
Reviewed by: the ports list
Tested by: make index (XFREE86_VERSION=3 only)
(2) Add hebrew to list of valid categories.
Submitted by: nbm
bsd.port.mk rev. 1.304 for details on the change.
The fix here is one of the following.
(1) Define USE_BZIP2 instead of BUILD_DEPENDS on bzip2 and redefining
EXTRACT_* commands.
(2) Change ${EXTRACT_CMD} to ${TAR} when the command is obviously
calling the "tar" command (i.e., arguments like "-xzf" are spelled
out).
(3) If ${EXTRACT_CMD} is called directly with ${EXTRACT_BEFORE_ARGS},
add ${EXTRACT_AFTER_ARGS} to the command line as well.
(4) If any of EXTRACT_CMD, EXTRACT_BEFORE_ARGS or EXTRACT_AFTER_ARGS
is set, define the other two too.
set, so mark them with MANCOMPRESSED=no. Note that this requires the
new bsd.port.mk that is not committed yet (going through final tests,
will be committed in a few hours).
