supports them. This is determined by running ``configure --help'' in
do-configure target and set the shell variable _LATE_CONFIGURE_ARGS
which is then passed to CONFIGURE_ARGS.
- Remove --mandir and --infodir in ports' Makefile where applicable
Few ports use REINPLACE_CMD to achieve the same effect, remove them too.
- Correct some manual pages location from PREFIX/man to MANPREFIX/man
- Define INFO_PATH where necessary
- Document that .info files are installed in a subdirectory relative to
PREFIX/INFO_PATH and slightly change add-plist-info to use INFO_PATH and
subdirectory detection.
PR: ports/111470
Approved by: portmgr
Discussed with: stas (Mk/*), gerald (info related stuffs)
Tested by: pointyhat exp run
We have not checked for this KEYWORD for a long time now, so this
is a complete noop, and thus no PORTREVISION bump. Removing it at
this point is mostly for pedantic reasons, and partly to avoid
perpetuating this anachronism by copy and paste to future scripts.
base rcorder, hard coded variable values in these scripts
are overriding the values in /etc/rc.conf[.local] (due to
the way that variables from the latter are read at boot time).
Therefore, change the boot scripts to set default values only
if the variable is unset in /etc/rc.conf[.local]. This will
allow the service to start at boot time if it's been enabled
as the user would expect.
This change will be a noop for users who have systems that
have not yet been upgraded to the new rc.d code in the base.
In many cases there are other variables in the scripts that
should get similar treatment, however I did not change
anything other than the _enable lines. I'll leave the rest
up to the maintainers to do as they see fit.
Bump PORTREVISION to make sure that users and packages
pick up this change.
