74f350ee08
ULP is a power saving feature that reduces the power consumption of the PHY when a cable is not connected. ULP is gated on the following conditions: 1) The hardware must support ULP. Currently this is only I218 devices from Intel 2) ULP is initiated by the driver, so, no driver results in no ULP. 3) ULP's implementation utilizes Runtime Power Management to toggle its execution. ULP is enabled/disabled based on the state of Runtime PM. 4) ULP is not active when wake-on-unicast, multicast or broadcast is active as these features are mutually-exclusive. Since the PHY is in an unavailable state while ULP is active, any access of the PHY registers will fail. This is resolved by utilizing kernel calls that cause the device to exit Runtime PM (e.g. pm_runtime_get_sync) and then, after PHY access is complete, allow the device to resume Runtime PM (e.g. pm_runtime_put_sync). Under certain conditions, toggling the LANPHYPC is necessary to disable ULP mode. Break out existing code to toggle LANPHYPC to a new function to avoid code duplication. Signed-off-by: Dave Ertman <davidx.m.ertman@intel.com> Cc: Bruce Allan <bruce.w.allan@intel.com> Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com> |
||
|---|---|---|
| .. | ||
| e1000 | ||
| e1000e | ||
| i40e | ||
| i40evf | ||
| igb | ||
| igbvf | ||
| ixgb | ||
| ixgbe | ||
| ixgbevf | ||
| e100.c | ||
| Kconfig | ||
| Makefile | ||