linux-hardened/drivers/usb/serial
Frank Schäfer c23bda365d usb: pl2303: add two comments concerning the supported baud rates with HX chips
I've found some new datasheets which describe some additionally
supported standard baud rates and I've verified them with my HX
(rev. 3A) device. But adding support for individual (chip type
specific) baud rates would add a good amount of extra code (especially
when support for further chips will be added to the driver one day),
which makes no sense as long as we are not using the direct baud rate
encoding method for newer chips.
So for now, just drop a comment about these additionally supported baud
rates.

The second comment is about the baud rate differences between the two
encoding methods. In theory, we could optimize the code a bit by
comparing the resulting baud rates of both methods and selecting the
one which is closer to the requested baud rate. But that seems to be a
bit overkill, because the differences are very small and the device
likely uses the same baud rate generator for both methods so that the
resulting baud rate would be the same.

Signed-off-by: Frank Schäfer <fschaefer.oss@googlemail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2013-08-12 15:43:41 -07:00
..
aircable.c TTY: switch tty_flip_buffer_push 2013-01-15 22:30:15 -08:00
ark3116.c USB: serial: make minor allocation dynamic 2013-06-17 13:30:02 -07:00
belkin_sa.c TTY: switch tty_flip_buffer_push 2013-01-15 22:30:15 -08:00
belkin_sa.h
bus.c USB: serial: ports: add minor and port number 2013-06-10 14:46:40 -07:00
ch341.c USB: ch341: fix TIOCMIWAIT and disconnect 2013-03-25 13:50:52 -07:00
console.c USB: console: remove unnecessary operations test 2013-07-23 16:24:32 -07:00
cp210x.c Merge 3.11-rc3 into usb-next 2013-07-29 07:43:16 -07:00
cyberjack.c USB: cyberjack: fix disconnect handling 2013-03-25 13:48:26 -07:00
cypress_m8.c USB: serial: set drain delay at port probe 2013-07-23 16:21:50 -07:00
cypress_m8.h USB: Serial: cypress_M8: Enable FRWD Dongle hidcom device 2013-06-03 10:33:10 -07:00
digi_acceleport.c USB: serial: ports: add minor and port number 2013-06-10 14:46:40 -07:00
empeg.c USB: serial: remove driver version information 2012-10-31 12:48:06 -07:00
ezusb_convert.pl
f81232.c USB: serial: set drain delay at port probe 2013-07-23 16:21:50 -07:00
ftdi_sio.c Merge 3.11-rc4 into usb-next 2013-08-05 08:36:14 +08:00
ftdi_sio.h USB: ftdi_sio: add support for FT-X series devices 2012-03-14 15:43:05 -07:00
ftdi_sio_ids.h USB: serial: ftdi_sio: add more RT Systems ftdi devices 2013-07-29 13:38:38 -07:00
garmin_gps.c USB: serial: ports: add minor and port number 2013-06-10 14:46:40 -07:00
generic.c USB: serial: remove hupping check from tiocmiwait 2013-07-23 16:21:50 -07:00
io_16654.h
io_edgeport.c USB: io_edgeport: remove unused defines 2013-07-23 16:28:22 -07:00
io_edgeport.h
io_ionsp.h
io_tables.h USB: io_edgeport: switch to generic TIOCMIWAIT implementation 2013-03-25 13:50:53 -07:00
io_ti.c USB: io_ti: move port initialisation to probe 2013-07-23 16:28:23 -07:00
io_ti.h
io_usbvend.h
ipaq.c USB: serial: remove driver version information 2012-10-31 12:48:06 -07:00
ipw.c USB: serial: remove driver version information 2012-10-31 12:48:06 -07:00
ir-usb.c TTY: switch tty_flip_buffer_push 2013-01-15 22:30:15 -08:00
iuu_phoenix.c USB: iuu_phoenix: fix bulk-message timeout 2013-05-29 10:50:43 +09:00
iuu_phoenix.h
Kconfig USB: serial: move the "simple" drivers into usb-serial-simple.c 2013-08-12 12:14:52 -07:00
keyspan.c USB: serial: ports: add minor and port number 2013-06-10 14:46:40 -07:00
keyspan.h USB: keyspan: fix NULL-pointer dereferences and memory leaks 2012-10-25 09:37:13 -07:00
keyspan_pda.c USB patches for 3.10-rc1 2013-04-29 12:19:23 -07:00
keyspan_usa26msg.h
keyspan_usa28msg.h
keyspan_usa49msg.h
keyspan_usa67msg.h
keyspan_usa90msg.h
kl5kusb105.c USB: kl5kusb105: always disable uart on close 2013-03-25 13:54:31 -07:00
kl5kusb105.h
kobil_sct.c USB: kobil_sct: use port interrupt-out urb 2013-04-17 10:05:35 -07:00
kobil_sct.h
Makefile USB: serial: move the "simple" drivers into usb-serial-simple.c 2013-08-12 12:14:52 -07:00
Makefile-keyspan_pda_fw
mct_u232.c USB: mct_u232: clean up read implementation 2013-04-17 10:05:35 -07:00
mct_u232.h
metro-usb.c USB: serial: ports: add minor and port number 2013-06-10 14:46:40 -07:00
mos7720.c USB: serial: make minor allocation dynamic 2013-06-17 13:30:02 -07:00
mos7840.c Merge 3.11-rc4 into usb-next 2013-08-05 08:36:14 +08:00
navman.c TTY: switch tty_flip_buffer_push 2013-01-15 22:30:15 -08:00
omninet.c USB: omninet: switch to generic read implementation 2013-04-17 10:05:34 -07:00
opticon.c USB: serial: make minor allocation dynamic 2013-06-17 13:30:02 -07:00
option.c usb: serial: option.c: remove ONDA MT825UP product ID fromdriver 2013-07-25 11:28:31 -07:00
oti6858.c USB: oti6858: do not call set_termios with uninitialised data 2013-07-23 16:24:33 -07:00
oti6858.h
pl2303.c usb: pl2303: add two comments concerning the supported baud rates with HX chips 2013-08-12 15:43:41 -07:00
pl2303.h USB: serial: pl2303: rm duplicate id 2011-11-15 10:06:15 -08:00
qcaux.c qcaux: add Franklin U600 2013-03-11 11:09:17 -07:00
qcserial.c USB: option,qcserial: move Novatel Gobi1K IDs to qcserial 2013-06-24 16:21:53 -07:00
quatech2.c USB: serial: make minor allocation dynamic 2013-06-17 13:30:02 -07:00
safe_serial.c USB: safe_serial: remove vendor/product module parameters 2013-07-23 16:28:23 -07:00
sierra.c USB: serial: ports: add minor and port number 2013-06-10 14:46:40 -07:00
spcp8x5.c USB: serial: set drain delay at port probe 2013-07-23 16:21:50 -07:00
ssu100.c USB: serial: make minor allocation dynamic 2013-06-17 13:30:02 -07:00
symbolserial.c USB: symbolserial: move private-data allocation to port_probe 2013-04-17 10:05:35 -07:00
ti_usb_3410_5052.c Merge 3.11-rc3 into usb-next 2013-07-29 07:43:16 -07:00
ti_usb_3410_5052.h USB: serial: ti_usb_3410_5052: new device id for Abbot strip port cable 2013-06-19 15:54:45 -07:00
usb-serial-simple.c USB: serial: move the "simple" drivers into usb-serial-simple.c 2013-08-12 12:14:52 -07:00
usb-serial.c USB: serial: clean up dtr_rts 2013-07-23 16:21:50 -07:00
usb-wwan.h USB: usb-wwan: fix multiple memory leaks in error paths 2012-10-25 09:37:13 -07:00
usb_debug.c USB: serial: rework usb_serial_register/deregister_drivers() 2012-05-08 15:46:14 -07:00
usb_wwan.c USB: serial: make minor allocation dynamic 2013-06-17 13:30:02 -07:00
visor.c USB: visor: fix initialisation of Treo/Kyocera devices 2013-05-29 10:47:45 +09:00
visor.h
whiteheat.c USB: serial: make minor allocation dynamic 2013-06-17 13:30:02 -07:00
whiteheat.h
wishbone-serial.c USB: serial: wishbone-serial: fix up minor sparse warning 2013-04-11 08:45:34 -07:00
xsens_mt.c usb: add driver for xsens motion trackers 2013-01-25 09:56:54 -08:00
zte_ev.c USB: option,zte_ev: move most ZTE CDMA devices to zte_ev 2013-06-06 09:06:25 -07:00