bed90dfd1a
By default qemu will try to create some sort of backend for the
emulated VGA device, either SDL or VNC.
However when the user specifies sdl=0 and vnc=0 in their configuration
libxl was not explicitly disabling either backend, which could lead to
one unexpectedly running.
If either sdl=1 or vnc=1 is configured then both before and after this
change only the backends which are explicitly enabled are configured,
i.e. this issue only occurs when all backends are supposed to have
been disabled.
This affects qemu-xen and qemu-xen-traditional differently.
If qemu-xen was compiled with SDL support then this would result in an
SDL window being opened if $DISPLAY is valid, or a failure to start
the guest if not. Passing "-display none" to qemu before any further
-sdl options disables this default behaviour and ensures that SDL is
only started if the libxl configuration demands it.
If qemu-xen was compiled without SDL support then qemu would instead
start a VNC server listening on ::1 (IPv6 localhost) or 127.0.0.1
(IPv4 localhost) with IPv6 preferred if available. Explicitly pass
"-vnc none" when vnc is not enabled in the libxl configuration to
remove this possibility.
qemu-xen-traditional would never start a vnc backend unless asked.
However by default it will start an SDL backend, the way to disable
this is to pass a -vnc option. In other words passing "-vnc none" will
disable both vnc and sdl by default. sdl can then be reenabled if
configured by subsequent use of the -sdl option.
Tested with both qemu-xen and qemu-xen-traditional built with SDL
support and:
xl cr # defaults
xl cr sdl=0 vnc=0
xl cr sdl=1 vnc=0
xl cr sdl=0 vnc=1
xl cr sdl=0 vnc=0 vga=\"none\"
xl cr sdl=0 vnc=0 nographic=1
with both valid and invalid $DISPLAY.
This is XSA-119.
|
||
|---|---|---|
| .. | ||
| files | ||
| patches | ||
| DESCR | ||
| distinfo | ||
| Makefile | ||
| MESSAGE | ||
| MESSAGE.NetBSD | ||
| PLIST | ||